Ask a Question
Advertise on boostr.in
boostr.in questions - Question:SMITH was running a form in the debug mode and begins to step through the code of a lengthy subprogram. After stepping through a few lines of its code, he realized that the error came not from the code in that particular subprogram but from code that is executed after it. At this point, how can he jump to the next line of code after the call to the subprogram?
a. ¬†¬†¬†¬†¬†¬†¬†Clicking Step Over to step over the execution of the subprogram
b. ¬†¬†¬†¬†¬†¬†¬†Opening the Stack panel, selecting the previous stack frame, and clicking Go
c. ¬†¬†¬†¬†¬†¬†¬†Clicking Step Out to resume stepping through code after the subprogram is called
d. ¬†¬†¬†¬†¬†¬†¬†HE cannot do this in the same debug session. He should click Stop, set a breakpoint immediately after the subprogram code is called, and run the form in debug mode again
Sep 13, 2013
Sep 12, 2013
to add a comment.
Your name to display (optional):
Email me at this address if my answer is selected or commented on:
Email me if my answer is selected or commented on
Privacy: Your email address will only be used for sending these notifications.
To avoid this verification in future, please